The AirTAC BL filter oil cup BL2000-003 is a genuine A/B-line lubricator with PT1/4" ports. It is the compact air-preparation line and oil-mist lubrication with a transparent sight dome. Flow is confirmed from the datasheet on request.
BL2000-003 is a replacement spare part for the AirTAC BL2000 lubricator, the larger B-line body in AirTAC's compact A/B series. It carries the BL2000's 1/4 in. PT-threaded port configuration, so it is intended to service an existing BL2000 unit rather than to add a new function to your air line. Use it as the replacement component it is - a bowl, cup or fitting for that unit.
This is a genuine AirTAC part in the compact A/B line. The complete BL2000 it serves is an oil-mist lubricator for compressed air with a transparent sight dome for checking the drip rate and a PC bowl protected by a high-strength plastic cover. Spare-part fitment, the datasheet and any figures you need are confirmed on request - just contact us with your unit's full code.
| Model | Airtac BL filter oil cup BL2000-003 |
|---|---|
| Type | Air Lubricator |
| Line | B-line (compact A/B air preparation) |
| Port size | PT1/4" (PT thread) |
| Fluid | Compressed air |
|---|---|
| Max. inlet pressure | 1.0 MPa (145 psi) |
| Temperature range | -5 to +70 C (non-freezing) |
| Bowl material | PC (polycarbonate) |
| Lubrication | Oil-mist, transparent sight dome |
| Pressure drop | Low (catalogue-stated) |
Specifications follow the official AirTAC A/B-line air-preparation data. Drain type, filter grade, gauge and low-pressure options are set by the model-code suffix - see the description. Flow curves, weight and outline dimensions are not published in our data set — ask us and we confirm from the factory datasheet.
Spare parts are matched by the code on the label of the unit you are servicing. Check that your existing unit is a BL2000 with a PT-threaded 1/4 in. port before ordering this part; G (BSPP) and NPT threaded units use different part numbers, and the smaller A-line AL2000 takes different parts again. The -003 suffix marks this as a spare part, not a complete lubricator.
Flow is not published as a single rating for the BL2000 family, so if you are sizing a new installation rather than servicing one, ask us and we will confirm the datasheet figures for the complete unit before you order.
Keep a matching spare for the BL2000 that oils the cylinders on a carton-sealing line, so a cracked bowl does not idle the machine while a new lubricator is sourced.
Hold the correct replacement for the 1/4 in. PT lubricator feeding air tools at a stamping or press cell, keeping daily tool oiling on schedule.
Service the lubricator on bench-mounted air drivers and riveters in an assembly plant without replacing the whole unit or interrupting the point-of-use setup.
None is published as a single rated figure - flow depends on the complete BL2000 unit and your operating conditions, and it is not stated for a spare part. If you need flow or sizing data, ask us and we will confirm the relevant datasheet figures on request.
Match the code on your existing unit's label. BL2000-003 is the spare part for the B-line BL2000 lubricator in the 1/4 in. size with PT thread as standard. Units ordered with G (BSPP) or NPT threads, or the smaller A-line AL2000, use different parts. Send us your full code and we will confirm fitment.