
Genuine AirTAC free mount cylinder, order code MU12X25B from the MU12 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The MU12X25B takes the 25 mm stroke MU12 free mount cylinder and specifies the B male rod thread, so the Ø6 mm rod screws straight into a clevis, tool holder or custom tip without an intermediate nut. No S magnet is ordered on this code, keeping the piston plain for applications that do not need position detection.
Performance matches the rest of the MU12 family: a double acting Ø12 mm bore giving 56.5 N push and 42.4 N pull at 0.5 MPa across a 0.15-0.7 MPa pressure range, with piston speed controllable between 30 and 500 mm/s and a bumper cushion stopping the 25 mm stroke. The square body fixes from any of its four sides, is hard-anodized against wear, and needs no lubrication.
| Order code | MU12X25B |
|---|---|
| Product | Free Mount Cylinder |
| Stroke | 25 mm |
| Magnet | No magnet |
| Rod end | Male thread |
| Action | Double acting |
|---|---|
| Bore / rod | Ø12 / Ø6 mm |
| Standard strokes | 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 mm (max. 50 mm) |
| Force at 0.5 MPa | Push 56.5 N · pull 42.4 N |
| Port | M5×0.8 |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-0.7 MPa |
| Proof pressure | 1.2 MPa (175 psi) |
| Temperature | -20 to +70 °C |
| Piston speed | 30-500 mm/s |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0498..P0499), MU series theoretical force, specifications, strokes and ordering code.
Choose MU12X25B when the 25 mm stroke must end in a male thread for direct tooling attachment. MU12X25 gives the same stroke with a female thread, MU12X25S adds a magnet for sensor position reading while keeping the female thread, and if 25 mm overshoots your move, MU12X20 or MU12X15 shorten the travel on the same body.
The male rod thread screws directly into a small holder or punch, letting the 25 mm stroke drive a marking, staking or piercing tip on a bench fixture.
At 56.5 N push from the 12 mm bore this code presses snap fits or small bearings into place, with the bumper cushion softening the end of the 25 mm move.
The compact square body slips into narrow tooling where space is short, and the 25 mm male-threaded rod ejects finished small parts from a cavity.
Stroke 25 mm (tolerance +1.0/0 mm), bore 12 mm, rod 6 mm with a male thread, no magnet. Double acting, 56.5 N push and 42.4 N pull at 0.5 MPa, port M5x0.8, operating pressure 0.15-0.7 MPa, piston speed 30-500 mm/s, bumper cushion, temperature -20 to +70 C.
The square body can be fixed from any of its four sides, and several units can stand side by side; the R suffix is not ordered here, so this code mounts transversely. It follows JIS standards, uses a hard-anodized bore with a bidirectional piston seal, and runs without lubrication on air filtered by a 40 um element.