
Genuine AirTAC free mount cylinder, order code MU12X30 from the MU12 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The AirTAC MU12X30 extends the Dia 12 mm MU free-mount cylinder to a 30 mm stroke, one of the standard steps between 25 and 35 mm, with no magnet in the piston. That keeps the price down on cycles that only need a clean extend and retract, while the square body still bolts from any of its four sides and allows several cylinders side by side to save space.
The rod ends in a female thread, the port is M5x0.8, and the Dia 12 bore gives 56.5 N push and 42.4 N pull at 0.5 MPa through a Dia 6 mm rod. It runs on filtered air (40 um element) at 0.15-0.7 MPa, tolerates -20 to +70 C, and needs no lubrication. The body grooves remain for sensors, but with no magnet fitted no position signal is available.
| Order code | MU12X30 |
|---|---|
| Product | Free Mount Cylinder |
| Stroke | 30 mm |
| Magnet | No magnet |
| Rod end | Female thread |
| Action | Double acting |
|---|---|
| Bore / rod | Ø12 / Ø6 mm |
| Standard strokes | 5, 10, 15, 20, 25, 30, 35, 40, 45, 50 mm (max. 50 mm) |
| Force at 0.5 MPa | Push 56.5 N · pull 42.4 N |
| Port | M5×0.8 |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-0.7 MPa |
| Proof pressure | 1.2 MPa (175 psi) |
| Temperature | -20 to +70 °C |
| Piston speed | 30-500 mm/s |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0498..P0499), MU series theoretical force, specifications, strokes and ordering code.
Order MU12X30 when you want the 30 mm stroke without sensing. Adding the magnet makes it MU12X30S, the axial mounting variant is MU12X30R, and the neighbouring strokes are MU12X25 and MU12X35. If 30 mm is still short, MU12X50 reaches the series maximum.
A 30 mm stroke clears small cartons or trays from chutes and nests where a shorter 25 mm body would fall short.
Bolt the body transversely under a machine plate and use the 56.5 N push at 0.5 MPa for light lids, stops and clamps.
The bumper cushion and 30-500 mm/s speed range suit quick flicking of defective parts off a narrow conveyor line.
Dia 12 mm bore, Dia 6 mm rod, 30 mm stroke (tolerance +1.0/0 mm), push 56.5 N and pull 42.4 N at 0.5 MPa, port M5x0.8, operating pressure 0.15-0.7 MPa, proof pressure 1.2 MPa (175 psi), temperature -20 to +70 C, piston speed 30-500 mm/s, bumper cushion, no piston magnet, female rod thread.
Not with this code as ordered, because no magnet is fitted, even though the body grooves accept CMSH, DMSH or EMSH sensors. If feedback matters, order MU12X30S instead, which carries the piston magnet and works with those sensors without brackets.