
Genuine AirTAC piston pressure regulator, order code SDR20008J1 from the SDR range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The J in SDR20008J1 deletes the mounting bracket, leaving a leaner SDR200 piston back-pressure regulator with PT1/4 ports and the standard 0.05-0.9 MPa regulating range. The structure stays the same proven piston type: simple, compact and easy to install where space or cost is tight.
You still get a gauge on this build, scaled in MPa by the trailing digit 1, and the pressure limits are unchanged from the series: 1.0 MPa (145 psi) maximum, 1.5 MPa proof pressure, -20 to +70 C. Plan your own fixing method, since only the bracket has been removed.
| Order code | SDR20008J1 |
|---|---|
| Product | Piston Pressure Regulator |
| Model and port | SDR200 · PT1/4 |
| Type and bracket | Standard, no bracket (J) |
| Pressure gauge | MPa gauge (1) |
| Structure | Piston back-pressure type |
|---|---|
| Fluid | Air |
| SDR100 ports | M5 / 1/8 |
| SDR200 ports | 1/8 / 1/4 |
| Regulating range | 0.05-0.9 MPa (standard), 0.03-0.4 MPa (L) |
| Max. pressure | 1.0 MPa (145 psi) |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
Source: AirTAC Products Catalog 2026A (PDF01-P0274), SDR series specifications and ordering code.
Take SDR20008J1 over SDR200081 when the regulator will be held by your own panel cutout, manifold or piping support and the bracket would go unused. Compared with SDR20008J2T, this PT-threaded code carries an MPa gauge instead of the NPT-and-psi combination, and if the setpoint can reach up to 0.9 MPa you need this standard type rather than the low-pressure SDR20008L1.
Drop the bracket and seat the PT1/4 regulator directly into an existing manifold or control panel with your own fixings.
Fit pressure regulation into tight cabinets on older equipment, where the deleted bracket shortens the installed footprint.
Match an existing SDR200 installation that was ordered with code J, keeping the MPa gauge reading consistent with the panel.
PT1/4 ports, standard 0.05-0.9 MPa regulating range, maximum pressure 1.0 MPa (145 psi), proof pressure 1.5 MPa, air fluid, -20 to +70 C operating temperature, MPa gauge included, no bracket fitted.
Code J means without bracket; the blank position on SDR200081 would include one. Everything else on the SDR200 body, including the PT1/4 ports and the MPa-scale gauge from digit 1, stays as standard.