
Genuine AirTAC adjustable mounting height stopper cylinder, order code TWG40X20SK from the TWG40 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The AirTAC TWG40X20SK pairs the TWG40 flange-mounted stopper cylinder with the K stopper head: a lever roller backed by an adjustable oil cushion, so arriving loads decelerate into the stop instead of striking a hard rod. The 40 mm bore runs on 0.15-1.0 MPa shop air through a PT1/8 port, and the 20 mm stroke lifts the lever clear of the conveyor surface when air is applied.
As a double acting cylinder it raises and lowers under air pressure on both strokes, with a bumper cushion at end of travel. The S suffix adds a piston magnet, so magnetic position switches can report up and down states without external brackets. No lubrication is required; use air filtered by a 40 um element and the unit serves -20 to +70 C.
| Order code | TWG40X20SK |
|---|---|
| Product | Adjustable mounting height Stopper Cylinder |
| Stroke | 20 mm |
| Stopper | Lever roller, adjustable oil cushion |
| Magnet | Magnet |
| Action | Double acting |
|---|---|
| Mounting | Flange, adjustable mounting height |
| Bore | Ø40 mm |
| Strokes | 20, 25, 30 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0756..P0757), TWG series specifications and ordering code.
Within the TWG40 ordering table this code selects stroke 20, the K lever roller stopper with adjustable oil cushion, and the S magnet. Pick TWG40X20SKF if the stopped load must not be pushed back when the lever springs; TWG40X20SR if a plain roller without the oil cushion is enough. If a 20 mm lift (tolerance +1.0/0 mm) is short, the same bore is available with 25 or 30 mm strokes.
The lever roller with adjustable oil cushion absorbs impact as accumulating pallets arrive, then the 20 mm stroke drops the stopper to release the flow.
The S magnet feeds up/down position signals to the sorter controller so gated cartons are only released after the stopper is confirmed lowered.
Workpieces parked ahead of a robot pick position benefit from the softened stop of the oil cushion, reducing bounce at the fixture edge.
40 mm bore, 20 mm stroke (tolerance +1.0/0 mm), double acting, flange mounting with adjustable height, PT1/8 port, operating pressure 0.15-1.0 MPa, proof pressure 1.5 MPa (215 psi), temperature -20 to +70 C, bumper cushion, lever roller stopper with adjustable oil cushion, magnet included.
The S option embeds a magnet in the piston so magnetic position switches can detect the up and down end positions without added hardware. The TWG series needs no lubrication; feed it air filtered by a 40 um element.