Genuine AirTAC adjustable mounting height stopper cylinder, order code TWG40X25K from the TWG40 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The TWG40X25K takes the TWG series adjustable mounting height stopper cylinder in Dia 40 mm bore and 25 mm stroke and fits the K stopper end: a lever roller coupled to an adjustable oil shock absorber. The lever and roller present rolling contact to the incoming load, while the oil cushion absorbs part of the impact, giving a softer stop than the bumper-only rod ends. Air is supplied through the PT1/8 port at 0.15-1.0 MPa and the cylinder is double acting.
Like the rest of the series, it uses a bumper cushion, needs no lubrication, follows JIS standards and works on air filtered by a 40 um element, with proof pressure of 1.5 MPa (215 psi) and a temperature range of -20 to +70 C. The thicker piston rod of the Dia 40 body resists impact better than smaller stopper designs. No magnet is fitted on this code.
| Order code | TWG40X25K |
|---|---|
| Product | Adjustable mounting height Stopper Cylinder |
| Stroke | 25 mm |
| Stopper | Lever roller, adjustable oil cushion |
| Magnet | No magnet |
| Action | Double acting |
|---|---|
| Mounting | Flange, adjustable mounting height |
| Bore | Ø40 mm |
| Strokes | 20, 25, 30 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0756..P0757), TWG series specifications and ordering code.
The K code is the right choice when loads arrive fast or heavy and you want the adjustable oil cushion to take the edge off the impact instead of a bare rod. Against TWG40X25C (round rod), TWG40X25B (flat rod) and TWG40X25R (roller without the oil cushion), only the K version combines the lever roller with damping. If stopped loads can push the lever backwards after impact, order TWG40X25KF instead, which adds the F self-lock; stroke siblings are TWG40X20K and TWG40X30K.
Absorb the shock of pallets arriving at a stop station, with the lever roller easing contact and the oil cushion damping the hit before the load settles.
Gate pallets at forklift pick-up or hand-off positions where repeated impacts would hammer a rigid rod end, then lower the stopper to release the load.
Use the adjustable oil cushion to tune the stopping feel on a rig that cycles workpieces into a station, with the 25 mm stroke giving short, repeatable lift.
Dia 40 mm bore; 25 mm stroke, tolerance +1.0/0 mm; double acting; lever roller stopper (K) with adjustable oil shock absorber; PT1/8 port; operating pressure 0.15-1.0 MPa; proof pressure 1.5 MPa (215 psi); temperature -20 to +70 C; no magnet; flange mounting with adjustable stopper height.
Not on this code. The TWG40X25K has the lever roller and adjustable oil cushion but no self-lock. If the stopped load could spring the lever back and push the load in reverse, order the F version, TWG40X25KF, which adds the self-lock to the lever roller stopper.