
Genuine AirTAC adjustable mounting height stopper cylinder, order code TWG50X25R from the TWG50 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The TWG50X25R is the roller-head version of the AirTAC TWG50 adjustable-height stopper cylinder. The R code in the order string selects a roller stopper, so the load can roll onto and off the head instead of dragging across it, which suits accumulating pallets and cartons on live conveyors. It is double acting with a 25 mm stroke, and the flange mounting lets you set the stopper height on the machine rather than shimming it in.
The 50 mm bore works at 0.15-1.0 MPa with a 1.5 MPa (215 psi) proof pressure, and the piston rod is thicker than a standard cylinder rod to absorb impact from moving loads. Air should be filtered by a 40 um element, the bumper cushion takes the end-of-stroke shock, and no lubrication is required.
| Order code | TWG50X25R |
|---|---|
| Product | Adjustable mounting height Stopper Cylinder |
| Stroke | 25 mm |
| Stopper | Roller |
| Magnet | No magnet |
| Action | Double acting |
|---|---|
| Mounting | Flange, adjustable mounting height |
| Bore | Ø50 mm |
| Strokes | 20, 25, 30 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0756..P0757), TWG series specifications and ordering code.
Within the TWG50 family, the R code sets this cylinder apart from its siblings: TWG50X25C uses a plain round rod, TWG50X25B a flat rod, and TWG50X25K a lever roller with an adjustable oil cushion for softer stops. Pick this code when loads should roll over the stopper head. Note that the order code has no S, so there is no magnet and no reed-switch position signal; a TWG50X25SR would be needed if sensing is required. Stroke is fixed at 25 mm against the 20 mm and 30 mm variants, with a +1.0/0 mm tolerance.
Place the roller head across a conveyor lane so moving pallets roll up against it and queue without scraping the stopper surface.
Raise and lower the 25 mm roller stopper to release single cartons one at a time into a case packer or labelling station.
Cycle the double acting stopper so a pallet halts at the exact lift height for a forklift or pallet truck to engage cleanly.
50 mm bore, 25 mm stroke (+1.0/0 mm tolerance), roller stopper, no magnet, double acting, flange mounting with adjustable height, PT1/8 port, 0.15-1.0 MPa operating pressure, 1.5 MPa (215 psi) proof pressure, -20 to +70 C, bumper cushion, no lubrication required.
No. The TWG50X25R order code carries no S, so no magnet is built into the piston. If you need the stopper's up/down position sensed by a reed switch, order the magnet-equipped equivalent instead and confirm switch models from the datasheet.