
Genuine AirTAC adjustable mounting height stopper cylinder, order code TWG50X25SB from the TWG50 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
In the TWG50 ordering code, S adds a piston magnet and B selects the flat rod stopper, so the TWG50X25SB gives you a flat-faced contact head plus reed-switch capability in one cylinder. A flat rod presents a broad, stable face to boxes and totes with flat bottoms, spreading the contact load over a wider area than a round rod. The cylinder stays double acting with a 25 mm stroke on a 50 mm bore.
Because the magnet is built in, an external position switch can confirm whether the stopper is up or down without extra tooling; confirm compatible switch models from the datasheet. The unit runs on 0.15-1.0 MPa air (proof pressure 1.5 MPa / 215 psi) filtered by a 40 um element, uses a bumper cushion, operates from -20 to +70 C and needs no lubrication.
| Order code | TWG50X25SB |
|---|---|
| Product | Adjustable mounting height Stopper Cylinder |
| Stroke | 25 mm |
| Stopper | Flat rod |
| Magnet | Magnet |
| Action | Double acting |
|---|---|
| Mounting | Flange, adjustable mounting height |
| Bore | Ø50 mm |
| Strokes | 20, 25, 30 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0756..P0757), TWG series specifications and ordering code.
This code combines two options that its neighbours carry separately: TWG50X25B is the same flat rod without the magnet, and TWG50X25SC is the magnet version with a round rod instead. Choose the SB when you want both a wide flat contact face and electronic position feedback. If the load needs a gentler, cushioned stop, look at the lever-roller TWG50X25SK, which can also take the F self-lock option to keep the lever from springing the load backwards. Stroke stays at 25 mm among the 20 mm and 30 mm choices.
The flat rod face holds flat-bottomed totes squarely while a reed switch on the magnet confirms the stopper is actually raised.
Cycle the 25 mm stroke to gate flat-based cartons one by one, with the built-in magnet signalling up and down positions to the PLC.
Wire a switch to the magnetised piston so the controller verifies stopper state before allowing the next pallet transfer.
50 mm bore, 25 mm stroke (+1.0/0 mm tolerance), flat rod stopper with magnet, double acting, flange mounting with adjustable height, PT1/8 port, 0.15-1.0 MPa operating pressure, 1.5 MPa (215 psi) proof pressure, -20 to +70 C, bumper cushion, no lubrication required.
The B code's flat rod gives a wide, flat contact face, which suits boxes and totes with flat bottoms and spreads impact over more area. A roller head (R) lets loads roll over the stopper, and a round rod (C) is the simplest contact, so pick the flat rod when load stability against the face matters most.