
Genuine AirTAC adjustable mounting height stopper cylinder, order code TWG50X30R from the TWG50 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The TWG50X30R is the roller-head version of the AirTAC TWG50 adjustable-height stopper cylinder. It is double acting with a Dia 50 mm bore and a 30 mm stroke (tolerance +1.0/0 mm), flange mounted so the stopper height can be set directly on the machine frame. Air at 0.15 to 1.0 MPa raises and lowers the stopper, and the thicker piston rod is built to resist impact from stopped loads.
This code uses the R stopper option: a roller head. No magnet is built in, so this unit cannot drive position sensors; order the S suffix if sensing is required. It runs on filtered air (40 um element), needs no lubrication, follows JIS standards, and is fitted with a bumper cushion and a PT1/8 port.
| Order code | TWG50X30R |
|---|---|
| Product | Adjustable mounting height Stopper Cylinder |
| Stroke | 30 mm |
| Stopper | Roller |
| Magnet | No magnet |
| Action | Double acting |
|---|---|
| Mounting | Flange, adjustable mounting height |
| Bore | Ø50 mm |
| Strokes | 20, 25, 30 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0756..P0757), TWG series specifications and ordering code.
Within the TWG ordering table, R selects the roller stopper and no letter before it means no magnet. If your load needs a softer landing, K gives a lever roller with an adjustable oil cushion, and F can add self-lock on that lever only. C (round rod) and B (flat rod) are the fixed-face alternatives, and strokes 20 and 25 mm are the shorter siblings of this 30 mm unit. Confirm roller suitability from the catalog impact load and speed charts before sizing.
Flange-mounted stop that lifts into the path of pallets on a conveyor, with the 30 mm stroke giving enough travel for a clear stop-and-release cycle.
Positions where the cycle timing is handled by the PLC rather than by cylinder switches, so the magnet-free R version is sufficient.
Stops cartons in accumulation sections, with the roller head suited to loads that should not snag on a fixed rod face.
Dia 50 mm bore, 30 mm stroke (+1.0/0), double acting, roller stopper, no magnet, PT1/8 port, operating pressure 0.15-1.0 MPa, proof pressure 1.5 MPa (215 psi), temperature -20 to +70 C, bumper cushion, no lubrication required.
No. The magnet is fixed by the ordering code, and this code has no S suffix, so it is magnet-free. For sensor capability order the TWG50X30SR, which adds the magnet for position sensors; the roller stopper stays the same.