
Genuine AirTAC adjustable mounting height stopper cylinder, order code TWG50X30SB from the TWG50 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The TWG50X30SB combines a flat rod stopper face with the S magnet option on the AirTAC TWG50 adjustable-height stopper cylinder. The Dia 50 mm body is double acting and flange mounted, so the stopper height is set on the machine, and the 30 mm stroke (+1.0/0 mm) lifts the stop clear of the load path when air is applied.
The built-in magnet lets you fit position sensors to confirm whether the stopper is up or down, which matters at interlocked stations. Supply filtered air through the PT1/8 port at 0.15 to 1.0 MPa; the unit is rated to 1.5 MPa (215 psi) proof pressure, works from -20 to +70 C, uses a bumper cushion and needs no lubrication.
| Order code | TWG50X30SB |
|---|---|
| Product | Adjustable mounting height Stopper Cylinder |
| Stroke | 30 mm |
| Stopper | Flat rod |
| Magnet | Magnet |
| Action | Double acting |
|---|---|
| Mounting | Flange, adjustable mounting height |
| Bore | Ø50 mm |
| Strokes | 20, 25, 30 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0756..P0757), TWG series specifications and ordering code.
This code takes B, the flat rod, together with S for the magnet. If the load must roll or glide over a softer interface, compare R (roller) or K (lever roller with adjustable oil cushion, which also accepts the F self-lock); the flat rod is a fixed flat face. C is the round-rod equivalent with the same magnet. On this Dia 50 bore the stroke options are 20, 25 and 30 mm, so this 30 mm code is the longest travel in the series.
The magnet lets a sensor verify stopper position before the conveyor restarts, adding a check that magnet-free TWG50 builds cannot provide.
Stops and releases totes at transfer points, with the adjustable flange height matched to the roller or chain line.
The flat rod face presents a broad, flat surface to square cases against before the next packaging step.
Dia 50 mm bore, 30 mm stroke (+1.0/0), double acting, flat rod stopper, magnet included (S option), PT1/8 port, operating pressure 0.15-1.0 MPa, proof pressure 1.5 MPa (215 psi), temperature -20 to +70 C, bumper cushion, no lubrication required.
Per the ordering code, C is a round rod, B is this flat rod, R is a roller, and K is a lever roller with adjustable oil cushion. The self-lock suffix F applies to the lever roller K only, so on this B stopper there is no self-lock option to add.