
Genuine AirTAC fixed mounting height stopper cylinder, order code TWQ32X10C from the TWQ32 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The AirTAC TWQ32X10C combines the Dia 32 mm TWQ stopper cylinder with the C round rod end and a 10 mm stroke held to a +1.0/0 mm tolerance. It is double acting: air through the PT1/8 port raises and lowers the stopper across a 0.15-1.0 MPa working range, and the thicker piston rod is designed to resist impact better than a standard rod. Mounting uses through holes or the tapped holes at both ends, and no lubrication is required.
The round rod is the plainest stopper face in the TWQ32 range, presenting a solid contact point to an incoming pallet or carton. This order code carries no magnet, so it gives no switch feedback; the body does keep sensor grooves on two sides for customers who order the S magnet option. Fluid must be air filtered by a 40 um element, the bumper cushion absorbs the cylinder stroke, and the series follows JIS standards.
| Order code | TWQ32X10C |
|---|---|
| Product | Fixed mounting height Stopper Cylinder |
| Stroke | 10 mm |
| Stopper | Round rod |
| Magnet | No magnet |
| Action | Double acting |
|---|---|
| Mounting | Through holes, tapped both ends |
| Bore | Ø32 mm |
| Strokes | 10, 15, 20 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0760..P0761), TWQ series specifications and ordering code.
Pick TWQ32X10C when a firm, simple contact face does the job and scuffing on the load is not a concern. If the load has a finished surface, TWQ32X10R replaces the rod with a rolling roller, and TWQ32X10K adds a lever roller with an adjustable oil cushion for a softer stop; TWQ32X10B flat rod spreads the contact over a wider face. A higher stopper dwell is available as TWQ32X15C or TWQ32X20C, and magnetic sensing requires the S option in the order code.
Stops pallets at a fixed mounting height on roller or chain conveyor lines before transfer, with the Dia 32 mm bore sized from the catalog impact load charts.
Holds cartons in an accumulation lane where a plain round contact face is enough and the 0.15-1.0 MPa air supply is already on site.
Raises and lowers a stop at a machining or assembly cell, the 10 mm stroke (+1.0/0 mm) suiting shallow pockets and small lift windows.
Dia 32 mm bore, 10 mm stroke (+1.0/0 mm), double acting, C round rod stopper, PT1/8 port, operating pressure 0.15-1.0 MPa, proof pressure 1.5 MPa (215 psi), temperature -20 to +70 C, bumper cushion, no lubrication required, air filtered by a 40 um element.
This code is supplied with no magnet, so it sends no switch signal even though the body has sensor grooves on two sides. To get feedback from a reed or solid-state switch, order the variant with the S magnet option; confirm the groove-compatible switch series from the datasheet.