
Genuine AirTAC fixed mounting height stopper cylinder, order code TWQ32X10SB from the TWQ32 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
TWQ32X10SB decodes as a Dia 32 mm TWQ stopper cylinder with the S magnet option and the B flat-rod rod end, on a 10 mm stroke. The flat face gives the stopped load a broader contact edge than a round rod, and the built-in magnet lets switches seated in the two-sided sensor grooves confirm whether the stopper is raised or lowered. Air is applied through a PT1/8 port at 0.15-1.0 MPa in double acting mode.
Mounting is fixed height via through holes or the tapped holes at both ends, and the S magnet is what makes groove-mounted sensors meaningful; a sensor without this option sees nothing. The bumper cushion takes the stop, the thicker piston rod resists impact, and the series needs no lubrication and follows JIS standards, so the flat-rod face stays consistent shift after shift between -20 and +70 C.
| Order code | TWQ32X10SB |
|---|---|
| Product | Fixed mounting height Stopper Cylinder |
| Stroke | 10 mm |
| Stopper | Flat rod |
| Magnet | Magnet |
| Action | Double acting |
|---|---|
| Mounting | Through holes, tapped both ends |
| Bore | Ø32 mm |
| Strokes | 10, 15, 20 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0760..P0761), TWQ series specifications and ordering code.
Pick TWQ32X10SB over the no-magnet flat rod TWQ32X10B when a PLC must know the stopper state; drop to TWQ32X10C (round rod, magnet) only if a narrow point contact is preferred, or to TWQ32X10R if rolling contact matters. For heavy impacts needing a softer catch, step to TWQ32X10K, the lever roller with an adjustable oil shock absorber, whose optional F self-lock is not available on flat-rod codes. Stroke alternatives on this bore are 15 and 20 mm if 10 mm lift is too short.
The S magnet plus the body's sensor grooves feed a stopper-up or stopper-down signal to the controller before a transfer starts.
The flat-rod face stops pallets squarely at a workstation, with the 10 mm stroke keeping the catch low and quick on 0.15-1.0 MPa air.
A broad flat contact edge holds boxes steady where forklift or shuttle traffic delivers loads onto the conveyor.
Dia 32 mm bore, 10 mm stroke (+1.0/0), flat rod stopper with magnet, double acting, PT1/8 port, 0.15-1.0 MPa operating pressure, 1.5 MPa (215 psi) proof pressure, bumper cushion, -20 to +70 C, air filtered by a 40 um element, no lubrication required, through-holes or tapped-both-ends mounting, sensor grooves on two sides.
The S in TWQ32X10SB adds a piston magnet so reed or solid-state switches snapped into the body's grooves can signal position. The self-lock letter F is not applicable here; it is offered only on the K lever roller stopper. Confirm compatible switch models from the datasheet before ordering.