
Genuine AirTAC fixed mounting height stopper cylinder, order code TWQ32X20-B from the TWQ32 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The TWQ32X20-B pairs the 32 mm bore of the AirTAC TWQ series with the longest stroke in the range, 20 mm with a +1.0/0 tolerance, and a flat rod stopper head. Double acting air both raises the stop into the load path and retracts it, and the thicker piston rod of this fixed mounting height stopper cylinder resists impact from moving loads.
Air is filtered through a 40 um element and supplied at 0.15-1.0 MPa; proof pressure is 1.5 MPa (215 psi) and the working temperature spans -20 to +70 C. No lubrication is required, the body has sensor grooves on two sides, and mounting uses through holes or the tapped holes at both ends with a PT1/8 air port.
| Order code | TWQ32X20-B |
|---|---|
| Product | Fixed mounting height Stopper Cylinder |
| Stroke | 20 mm |
| Stopper | Flat rod |
| Magnet | No magnet |
| Action | Double acting |
|---|---|
| Mounting | Through holes, tapped both ends |
| Bore | Ø32 mm |
| Strokes | 10, 15, 20 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0760..P0761), TWQ series specifications and ordering code.
Pick X20 when the stopper needs 20 mm of lift to clear the load carrier below or retract far enough for traffic to pass over it. If your layout allows less travel, TWQ32X15-B gives 15 mm and TWQ32X10-B only 10 mm on the same flat rod head; all three share the 32 mm bore and PT1/8 port. For position feedback, order the S magnet version; this code has no magnet fitted.
Stops full pallets on roller or chain conveyors where 20 mm of flat rod lift clears the pallet runner underneath.
Presents a wide flat face to catch and hold totes at a pick station, using the through hole or tapped both-ends mounting.
Works as an end-of-queue stop in accumulation sections, sized with the catalog impact load and speed charts.
Bore 32 mm; stroke 20 mm (+1.0/0); double acting; flat rod stopper; no magnet; PT1/8 port; operating pressure 0.15-1.0 MPa; proof pressure 1.5 MPa (215 psi); temperature -20 to +70 C; bumper cushion; mounting by through holes or tapped holes at both ends.
Option B is the flat rod; siblings are C round rod, R roller and K lever roller with adjustable oil cushion, the latter also accepting the F self-lock. The flat face gives the stopped load more bearing area than the round rod. The body has sensor grooves on two sides, but this code ships without a magnet.