
Genuine AirTAC fixed mounting height stopper cylinder, order code TWQ32X20C from the TWQ32 range. The options this code selects are decoded below; series data follow the official AirTAC catalog.
The AirTAC TWQ32X20C is a fixed mounting height stopper cylinder with a 32 mm bore and a 20 mm stroke. Double acting air raises the round rod to block the load and retracts it to release the line, and the thicker piston rod of the TWQ32 series resists impact from moving product. The stroke closes on a bumper cushion with a +1.0/0 mm tolerance.
Mount it through the body holes or the tapped holes at both ends for a fixed stop height. The port is PT1/8, the fluid is air filtered by a 40 um element, and lubrication is not required. Sensor grooves on two sides of the body accept position switches, but this order code leaves the S magnet out, so built-in magnetic sensing is not fitted.
| Order code | TWQ32X20C |
|---|---|
| Product | Fixed mounting height Stopper Cylinder |
| Stroke | 20 mm |
| Stopper | Round rod |
| Magnet | No magnet |
| Action | Double acting |
|---|---|
| Mounting | Through holes, tapped both ends |
| Bore | Ø32 mm |
| Strokes | 10, 15, 20 mm (+1.0/0) |
| Port | PT1/8 |
| Stopper types | Round rod, Flat rod, Roller, Lever roller, adjustable oil cushion |
| Fluid | Air (filtered by 40 µm element) |
| Operating pressure | 0.15-1.0 MPa |
| Proof pressure | 1.5 MPa (215 psi) |
| Temperature | -20 to +70 °C |
| Cushion | Bumper |
| Lubrication | Not required |
Source: AirTAC Products Catalog 2026A (PDF01-P0760..P0761), TWQ series specifications and ordering code.
Within the TWQ32 ordering table this code pairs the longest 20 mm stroke with the C round rod end. Neighbours are TWQ32X20B for a flat rod, TWQ32X20R for a roller, and TWQ32X20K or TWQ32X20KF when the adjustable oil cushion of the lever roller is wanted; step down to TWQ32X15C or TWQ32X10C if 20 mm is more lift than the station needs.
Adding S to the order code (TWQ32X20CS) would supply the magnet that this code omits. Size the bore with the impact load and speed charts in the catalog before ordering.
On a roller or chain conveyor the round rod rises 20 mm to square up against the pallet frame, then retracts on command to let the load pass.
Queue cartons and totes in accumulating lanes where every stop must occur at one fixed height set by the mounting holes.
Present a workpiece against the round rod edge at a machining or assembly position, then let the line PLC signal the release stroke.
Bore 32 mm, stroke 20 mm with +1.0/0 mm tolerance, double acting with a bumper cushion, port PT1/8, operating pressure 0.15-1.0 MPa, proof pressure 1.5 MPa (215 psi), temperature -20 to +70 C, stopper type C round rod, no magnet fitted. Size the bore against the catalog impact load and speed charts.
Mounting is by through holes or the tapped holes at both ends, which fixes the stopper height. The body has sensor grooves on two sides, but the S magnet is not ordered here, so magnetic switches will not trip; choose a code with S if built-in magnetic sensing matters.